Updating Ecd Smartdry™ Cabinet Firmware And Network Dashboard - ECD SmartDRY SD Series Setup And Operation Manual

11.5 UPDATING ECD SMARTDRY™ CABINET FIRMWARE AND NETWORK DASHBOARD
Instruction to install new firmware for the ECD .
The firmware and dashboard files are provided by ECD Service/Test technicians via email or down-
load.
Please follow these steps to update the control firmware for all ECD SmartDRY™ models:
1) Unzip the zip file provided by ECD Service/Test technicians.
2) There is one folder in the Zip file: "Update" and this needs to be "Unzipped" to the root of a USB flash
drive.
3) Insert the flash drive containing the unzipped folder into the cabinet USB port located on the back next
to the power and network connections.
4) From the SmartDRY™ controller front panel, press the Menu button to selectSettings". Then select the
"Factory" button.
5) If you have set a Password, you will be prompted to enter that password and press OK. If not, you will
be prompted for a "Factory Code"
6) At the "Factory Code" touch the Code cell to select then use the up/down arrow buttons to enter the
number "123" (press and hold to count up or down quickly) and press OK.
7) The controller highlights the firmware file name and version. Press the OK button to start the firmware
upload process. The controller flashes the interior lights, displays a progress bar and then confirms
completion.
8) When complete, press the "Back" button to "back" out of the Factory screen.
SD Series Dry Cabinets Setup and Operation Manual | A62-3337-00 Rev: 1.0.0 Page 93