Setup And Installation; Power Source - ECD SmartDRY SD Series Setup And Operation Manual

5.0 SETUP AND INSTALLATION

The installation of the ECD SmartDRY™ Cabinet may be performed by the end user. Local, city, county, or
other jurisdictions may govern the use of this equipment. If you have any questions about local requirements,
please contact the appropriate local agency.
The ECD SmartDRY™ Cabinet is intended for indoor use only, at room temperatures between 15°C and 35°C, at
no greater than 80% relative humidity (at 25°C) and <2, 000 meters (6,561ft) elevation.

5.1 POWER SOURCE

The power requirements are listed on the cabinet serial number label. The supply voltage should not vary
more than 10%.
Position the unit to allow user access to the power cord for mains disconnect.
PLUG THE UNIT INTO A PROPERLY GROUNDED AND RATED RECEPTACLE OF THE CORRECT TYPE.
THE VOLTAGE AT THE RECEPTACLE SHOULD NOT VARY MORE THAN 10% FROM THE LISTED RAT-
ING.
SD Series Dry Cabinets Setup and Operation Manual | A62-3337-00 Rev: 1.0.0 Page 8