Power Board - ECD SmartDRY SD Series Setup And Operation Manual

10.5 POWER BOARD

Prior to any maintenance or service on this unit, disconnect the power cord from the power sup-
ply. Before reattaching the unit to its power supply, be sure all covers and the fastening hardware
are in place and secure.
Step 1 - Disassemble:
The Power Board has capacitors which can remain charged. Handle board from the edges only.
1) Remove the control chassis top cover.
Remove the 4 to 6 screws (model dependent) on the back of the top cover.
•
• Slide the top cover back about 2 cm (1/2").
• Lift up and disconnect light tower option, if included.
• Place top cover aside.
Connectors with a locking latch must have the latch pressed while carefully pulling the connector.
2) Disconnect all wire harnesses from Power Board.
SD Series Dry Cabinets Setup and Operation Manual | A62-3337-00 Rev: 1.0.0 Page 76