Table of Contents
Advertisement
Instruments and Controls
Wipers and Washers
Windscreen Wiper Operation
The wipers and washers will only operate
with the vehicle power system in the ACC/
ON/READY position. Operate the lever to
select different wipe speeds:
•
Intermittent wipe (1)
•
Slow wipe (2)
•
Fast wipe (3)
•
Single wipe (4)
•
Rain sensor sensitivity adjustment (5)
•
Programmed wash/wipe (6)
26
Intermittent Wipe
With automatic wipe, the vehicle will adjust
the wiping speed according to the signals
provided by rain sensor. Turn the switch (5)
to adjust the sensitivity of rain sensor. As
the sensitivity increases, the wiping interval
decreases.
Note: Immediately operating the wiper
one time can be achieved by increasing
the sensitivity of rain sensor. If the rain
sensor detects continuous rainwater, the
wiper will keep working. When no rain is
detected, it is recommended to switch off
automatic wipe.
Slow Wipe
By pushing the lever up to the slow wipe
position (2), the wipers will operate slowly.
Move the lever to re-select the wipe speed.
Fast Wipe
By pushing the lever up to the fast wipe
position (3), the wipers will operate fast.
Move the lever to re-select the wipe speed.
Single Wipe
Pressing the lever (4) down and releasing
will operate a single wipe, if the lever is held
down, the wipers will operate continuously
until the lever is released.
Note: When the car is stationary, if the
bonnet is opened, the front wiper/washer
will stop work immediately.
IMPORTANT
•
Avoid operating the wipers on a dry
windscreen.
•
In freezing or extremely hot weather
conditions, make sure that the wiper
blades are not frozen/adhered to the
windscreen.
•
In winter, remove snow or ice from
around the arms and blades, including
the wiped area of the screen.
Advertisement
Table of Contents
