Seats; Overview; Head Restraints - MG ZS EV Owner's Manual

Seats & Restraints

Seats

Overview

To avoid personal injuries due to
the loss of control, DO NOT adjust
the seats while the car is moving.
The vehicle is equipped with 6-direction or
4-direction adjustable front seats and 60/40
split rear seats with foldable backrests.
An ideal position of the seat should make
sure your driving position is comfortable,
which allows you to hold the steering wheel
with your arms and legs slightly bent and
control all the equipment. Make sure your
driving position is comfortable and enables
you to maintain full control of the vehicle.
Take care when adjusting the height of front
seats - the feet of the rear passenger could
become trapped when the seat is lowered.
Do not incline the front-seat backrest
excessively. Optimum benefit is obtained
from the seat belt with the backrest angle
set to approximately 25° from the upright
(vertical). The driver and front passenger
seats should be positioned as far rearward
as practical. A properly adjusted seat helps
reduce the risk of injury from sitting too close
to an inflating airbag.
54

Head Restraints

Adjust the height of the head
restraint so that the top of it is in
line with the top of the occupant's
head. This location may reduce the
risk of head and neck injuries in the
event of a collision. DO NOT adjust
or remove the head restraints while
the car is moving.
DO NOT hang anything on any
head restraint or head restraint rod.
The head restraint is designed to prevent
rearward movement of the head in the event
of a collision or emergency braking, thereby
reducing the risk of head and neck injuries.
When adjusting the head restraints from a
low to high position, pull the head restraint
directly upward, and gently press it downward
after it reaches the desired position to make
sure that it is locked in position. To remove
the head restraint, press and hold the guide
sleeve button (as indicated by the arrow) on
the left of the head restraint, then pull the
head restraint upward to remove it.
When adjusting the head restraints from a
high to low position, press the guide sleeve
button (as indicated by the arrow) on the
left of the head restraint, and press the head
restraint downward; release the button after
it reaches the desired position, and gently
press the head restraint downward to make
sure that it is locked in position.