Tool Identification; Tyre Repair - MG ZS EV Owner's Manual

Emergency Information
Note: When the new vehicle leaves the
factory, the dust cap of the valve may
be a little tight. It is recommended that
you remove the wheel trim cover first
during the first inflation operation, and
then screw off the dust cap when there is
enough space.
Note: If the pulling force required to
remove the wheel trim cover is large, use
a suitable tool to pull it out.
136

Tool Identification *

1 Repair Fluid
2 Electric Air Pump
3 Towing Hook
4 Wheel Bolt Cap Removal Tool
5 Warning Triangle

Tyre Repair *

1 Remove the label at the bottom of the
repair fluid reservoir and attach it to the
steering wheel to remind the driver not
to exceed 80 km/h.
2 Connect the air hose of the electric air
pump to the repair fluid reservoir, fit the
tyre sealant bottle (upright) into the slot
on the compressor. Remove the valve
dust cap of the flat tyre, and connect the
filler hose from the tyre sealant bottle
to the tyre valve. Ensure that the power
switch of the electric air compressor is
switched off (i.e., press "O"), then insert
the plug from the compressor into the
centre console power socket, and turn
the vehicle power system to ON/READY.