Wipers And Washers; Windscreen Wiper Operation - MG ZS11 Owner's Handbook Manual

Wipers and Washers

Windscreen Wiper Operation

The wipers and washers will only operate with the
START/STOP Switch in the ACC/ON/RUNNING position.
Operate the lever to select different wipe speeds:
• Intermittent wipe (1)
• Slow wipe (2)
INSTRUMENTS AND CONTROLS
• Fast wipe (3)
• Single wipe (4)
• Automatic wipe interval adjustment
sensitivity adjustment
• Programmed wash/wipe (6)
Intermittent Wipe
By pushing the lever up to the Intermittent wipe position
(1), the wipers will operate automatically. Turn the switch
*
(5) to adjust the intermittent wipe frequency. This speed
will also change with the vehicle speed. As the vehicle
speed increases, the wiper frequency increases. As the
vehicle speed decreases, the wiper frequency decreases.
Some models are equipped with a rain sensor fitted to the
interior rear view mirror base to detect varying amounts
of water on the outside of the windscreen. With automatic
wipe, the vehicle will adjust the wiping speed according to
the signals provided by rain sensor. Turn the switch (5)
to adjust the sensitivity of rain sensor. As the sensitivity
increases, the wiping interval decreases.
Note: Immediately operating the wiper one time can
be achieved by increasing the sensitivity of rain sensor.
*
/ Rain sensor
*
(5)
1
43