Table of Contents
Advertisement
Cleaning the Product Tanks
Step
1
2
3
4
5
6
7
8
9
10
11
12
Turn off power to the unit, by placing the power switch in the OFF position.
Open the front and top access doors of the unit.
Place an empty cup under the dispensing tube to catch any remaining product.
Open the product valve by pulling it out slightly and turning it counter-clockwise a
quarter of a turn. (Parallel to the dispensing tube slot.)
Repeat Steps 3 & 4 for the other two product tanks, if necessary
Remove the dispensing tubes from the tank(s) and discard. (See Error! Reference
source not found.)
Place the tanks and covers in the three compartment sink, filled with a Dunkin
approved dairy dispenser detergent. Let tanks soak for 5 minutes.
NOTE: Make sure to follow manufacturer's specifications.
Thoroughly brush-clean the tanks and covers. Make sure all product film is
removed from internal and external surfaces.
Thoroughly rinse the tanks and lids in warm water.
Rinse the tanks and covers in the sanitizing solution for a minimum of one (1)
minute.
Remove containers and lids from sanitizing solution, shake to remove excess
solution and place the parts on a clean, dry surface to air dry.
With an approved sanitizing solution, thoroughly clean the dispensing tube slots
and dispensing valves. Allow to air dry.
Figure 7. Dispensing Tubes and Product Tanks
Action
13
Advertisement
Table of Contents
