Refrigerated Product Compartment Cleaning; Cleaning Exterior Of Unit - Silver King SKDC12-ESUS1 Technical Manual

Refrigerated Product Compartment Cleaning

Each time a new product tank is loaded, check the refrigerated product compartment for ice buildup and dairy spillage. If
ice is noticeable, perform the following procedure to remove it.
Step
1
2
3
4
5
6
7
8

Cleaning Exterior Of Unit

To clean the exterior of the Unit, perform the following procedure.
Step
1
2
3
4
5
6
7
Turn off power to the unit, by placing the power switch in the OFF positions.
Open the front and top access doors of the unit and remove the product tank(s).
Check the refrigerated product compartment for ice buildup. If ice buildup is
noticeable, leave the door open for about 15 min. to allow the ice to soften.
Remove the ice by hand. NEVER use sharp objects to remove ice.
Wipe down the interior with a clean, soft cloth.
Dry thoroughly.
Close the front and top access doors of the unit.
Turn on power to the unit and let it run for 15-30 min. until the unit is cold.
Replace the product tank(s).
Press the up or down arrow until the display reads Panel Disable Press Select.
Press Select and the screen reads Panel Disable HLD HOM to Ext.
Use a soft, clean, dry cloth to wipe down the exterior surface of the unit. NOTE:
Never use abrasive materials or cleaners on the exterior of the unit.
Wash the stainless steel surfaces of the unit with warm, soapy water.
Rinse the surfaces with warm water.
Wipe the stainless steel surfaces dry with a clean, soft cloth prevent water
spotting. NOTE: stainless steel polish may be used, but is not required. Do not
spray directly on the unit. Wet the cloth with the polish.
Hold your finger on the Home button for 2-3 seconds to exit Panel Disable mode.
Action
Action
14