Related Manuals for Silver King SKFDI23
Summary of Contents for Silver King SKFDI23
- Page 1 Technical Manual Replacement Parts List Counter Top Drop-In Merchandiser MODEL SKFDI23 115V 1600 Xenium Lane North, Minneapolis, MN 55441-3787 Phone (763) 553-1881 FORM NO. 45364 REV C 02/2020 Specifications Subject to Change Without Notice.
- Page 2 INSPECT FOR DAMAGE AND UNCRATE Upon delivery of your new Silver King unit, uncrate at once to inspect for possible damage following the instructions printed on the exterior of the container. Report any damages to the carrier responsible for transportation and promptly present a claim for any evidence of mishandling.
- Page 3 Your Silver King refrigerator is equipped with an eight (8) foot power cord. Any attempt to modify the plug will void the warranty, terminate the manufacturers responsibility, and could result in serious injury.
-
Page 5: Operation
Defrost The Silver King counter-top drop-in display merchandiser is a manual defrost unit. The unit should be defrosted whenever the walls accumulate a frost layer that is 1/4 inch thick. To defrost the unit, either move the power switch to the ‘off’ position or disconnect the Power Cord from the electrical receptacle, and remove the Lid Assembly. - Page 7 REPLACEMENT PARTS LIST – SKFDI23 ITEM NO. PART DESCRIPTION PART NO. COVER ASSEMBLY 61522 GUIDE PIN LID 21113 GASKET LID 10310-36 HINGE BRACKET LEFT 21666 HINGE BRACKET RIGHT 23046 FAN MOTOR 115V/60 39577 CONDENSER COIL 39255 DRIER 22677 POWER SOURCE CORD 115V...
- Page 9 Thermistor Field Testing Use the guide below to test if a thermistor (temperature probe) is functioning properly. See the replacement parts list for part number information. Table 2 is valid for all thermistors listed on table 1. • Establish Thermistor Temperature ▪...
- Page 10 Silver King’s review to be inefficient or inoperative due to defects in material or factory workmanship.
- Page 11 Equipment, that it will replace the compressor with one of similar design and capacity, exclusive of delivery and installation charges, if it is found subject to Silver King’s review to be inefficient or inoperative due to defects in material or factory workmanship. It is the original purchaser’s responsibility to return the serial plate of the defective compressor, or at Silver King’s option the complete compressor, to the factory.
- Page 12 (Returned Merchandise Authorization) form must be completed and then approved by Silver King. Please contact Silver King for details. Restocking fee will apply. • All electrical equipment is single phase. • Prices, designs, and specifications are subject to change without notice. • Payments via credit card are subject to a 3.5% surcharge.