Table of Contents
Advertisement
Installation
3.3.2 DC Cabling Installation for M80U
Please read the following instructions for attaching DC terminals (M80U
• It is important to choose the proper size for DC cable.
• The cross-sectional area for each internal cable is 2~3/0 AWG.
• It is important to choose the correct fixing screws.
• Each individual screw with torque 8.0N-m is required.
• The bending space is 160 mm which meets the safety standard.
• 2½" EMT are applied to DC Terminals connection as seen in Figure 3-15.
- The screw with torque 8.0N-m is required for fixing.
- The required bending space is 160 mm as the requirement states.
ATTENTION
Figure 3-14 : Wiring Box layout for M80U
30
_121
+
+
IN 1
-
-
+
+
IN 2
-
-
PE
PE
) :
_121
Advertisement
Table of Contents
