3 Installation
- The unit should not be installed in direct sunlight.
- Do not install the unit near or on flammable surfaces.
- Please mount the unit tightly on a solid / smooth surface.
The chapter contains instructions for (1) Mechanical installation; (2) Electrical
Installation; (3) Communication setup.
3.1 Mechanical Installatio
This unit is designed to be wall-mounted. Please ensure that the installation is
perpendicular to the floor and the AC and DC terminal are at the bottom position.
Please follow the instruction as shown from Figure 3-1 through 3-3. First, fix the
wall mounting bracket on a solid support surface. Second, please mount the
inverter on the bracket securely. Note that Figure 3-1 through 3-6 should be
followed.
To mount the inverter on the wall, please follow the procedure :
1. Screw the wall mounting bracket on the wall with at least 8 M8 Phillips head
screws. Please refer to Figure 3-1 and 3-2 for correct installation.
2. Hang the inverter on the wall mounting bracket.
3. There are two ways for fixing the wall mounting bracket as shown in Figure 3-2.
- Please fix at least 8 M8 Phillips head screws for the wall mounting bracket.
- The bracket shipped with the unit is specially designed and should be the only
mounting device for the mechanical installation.
CAUTION !
WARNING !
CAUTION !
17
Installation