Install/Remove Output Stacker; Open The Output Stacker Cover And Remove The Cards; Use The Spring Load To Remove A Small Quantity Of Cards; Remove The Output Stacker And The Cards - NBS Technologies Javelin DNA User Manual

Install/Remove Output Stacker

The Output Stacker can be installed or removed as follows:
Option 1: Open the Output Stacker cover and remove the cards.
Option 2: Use the spring load to remove a small quantity of cards.
Option 3: Remove the Output Stacker and the cards.
-Open the Output Stacker Cover and Remove
the Cards
Lower the Output Stacker cover until it latches as shown in the picture.
Use this method when printing a small quantity of cards and check the
results right away.
30
-Use the Spring Load to Remove a Small Quantity
of Cards.
This method is recommended when printing
fewer than 5 cards.
The Output Stacker is spring loaded so that
it returns to its original position when the
cards are removed.

- Remove the Output Stacker and the Cards.

Push the Output Stacker
and pull it forward and
then pull it back to
remove it as shown in
the picture.
This method is recom-
mended for printing
more than 50 cards, and
up to 60 cards can be
loaded in this way.
31
JAVELIN DNA User Guide Manual