NBS Technologies Javelin DNA User Manual page 42

-Warning
①Card
Code Code Name Description
IC fails to make
23 [IC] Contact Error
contact.
[MS] Encoder An MS encoding
24
Error error occurs.
All 3 MS tracks fail to
25 [MS] Read Error
read.
[MS] Read STX No STX is found in the
26
Error MS reading.
A parity error occurs
[MS] Read Parity
27
in the MS reading.
Error
[MS] Read ETX No ETX is found in the
28
Error
MS reading.
[MS] Read LRC
LRC is inconsistent in the
29
Error
MS reading.
IC module
IC Module
30
communication fails.
Response Timeout
31 RF Module
RF module
Response Timeout
communication fails.
Flipper module
33 Card Eject Error
communication fails.
The card input is
Card Input
34
interrupted.
Timeout
② Ribbon
Code Code Name Description
The ribbon life is reduced
35
Ribbon Life Low
to 10% or less.
The ribbon is fully
36 No Ribbon Life
consumed.
RF Tag Ribbon T h e r i b b o n i s n o t
38
Error installed properly.
③ SAM
Code Code Name Description
SAM Module SAM module
32
Response Timeout communication fails.
82
Solution
Check the IC contact module.
Check the MS module.
Check the MS module.
Check the MS feeding.
Check the MS feeding
Check the MS feeding.
Check the MS feeding and
replace the MS card.
Check the IFM B/D.
Check the IFM B/D.
Check the Flipper and Flipper
B/D.
Check the Input Hopper and for
any jammed cards.
Solution
Prepare to replace the ribbon.
Replace the ribbon with a new
one.
Check the ribbon and tag
authentication.
Solution
Check the SAM B/D interface
and SAM B/D.
④ Miscellaneous
Code Code Name Description
The command is not
20 Command Error compliant with the
specifications.
The parameter is not
21 Parameter Error
valid.
Main
The command is not sent
22
Communication Part
on time.
Timeout
One of the following steps must be taken to recover the printer from the error state:
1) Press the "RIBBON SET" button with the ribbon installed.
2) Press the "EJECT" button.
Caution
3) Turn off and on the power.
-Additional Errors
Errors
- Check the X-coordinate in the printer driver.
The ribbon is frequently cut at
- The recommended starting value for the X-coordinate is
the top of the card.
14 ± 2.
- Make sure that the printer driver is installed correctly.
The printer is unable to
find the Javelin Designer or - Check the connections of communication cables.
other programs.
- Reboot the PC.
Ribbon Specifications
-Colour Ribbons
Ribbon Type Specifications
YMCKO 200 Prints/Roll
1/2YMCKO
400 Prints/Roll
YMCKO-K
167 Prints/Roll
-Monochrome Ribbons
Ribbon Type Specifications
Blue
1000 Prints/Roll
Black 1000 Prints/Roll
Red
1000 Prints/Roll
Green 1000 Prints/Roll
White 1000 Prints/Roll
Metallic gold 1000 Prints/Roll
Metallic silver 1000 Prints/Roll
KO(black overlay) 500 Prints/Roll
Solution
Send compliant command.
Send the parameter command.
Send the command.
Solution
J200i/J230i DNA Series
J200i/J230i DNA Series
83
JAVELIN DNA User Guide Manual