NBS Technologies Javelin DNA User Manual page 20

(2) If they are in the same IP range, but the printer cannot be found
Check "Input by user" and click "Setting".
When the Network Configuration window pops up, the available printers will
be displayed.
Check the IP Address, Subnet Mask and Gateway and click "Setting".
Check DHCP to enable DHCP mode and click "Setting". If the settings are
entered correctly, the printer will initialize.
If the IP address and Board List are not specified in the Network Configuration
window, then they may be in a different IP address range or the printer is not
connected to the network. You will need to check your network settings.
38
5-3. Manual Installation (Connect to the printer using a USB connection)
If the printer is not automatically detected, connect to the printer using a USB
connection and configure the network settings.
(1) Retrieve Address via USB
Connect the printer to a PC using USB connection and click "USB Get
Address" to check the device's IP Address, Subnet Mask, Gateway and MAC
address.
(2) Set Address via USB
Check the values retrieved through "Retrieve Address via USB".
Enter the IP Address, Subnet Mask, and Gateway, and click "Set Address
via USB".
6. Click "Finish" to complete the installation process.
39
JAVELIN DNA User Guide Manual