3. Push the card to the front of the printer and then press the card to down.
Tilt the card 70~90 degree down in order to eject the card easily.
When the flipper is rotating, a card can be moved back and forth. Hold
Caution
a card tightly in order to prevent any movement of a card.
4. Pull out the card inside manually as shown in the below pictures.
80
③ Ribbon
Code
Code Name
Description
Disconnected ribbon,
Ribbon Encoder
14
Ribbon end or
Error
encoder error occurs.
④ Card
Code
Code Name
Description
IC Module Up/
IC Content module
17
Down Error
position error occurs.
Flipper
[Changer] Module
communication error
50
Response Timeout
occurs.
[Changer] Module
Flipper
Transmission
communication error
51
Timeout
occurs
An error occurs at the
[Changer] Home
52
Flipper home position.
Position Failure
An error occurs at
[Changer] Card
53
the Flipper turn up.
Flipper Failure
The printer stops when
[Changer] Card
the card is entering the
54
Input Timeout
Flipper.
[Changer] Card
The card fails to enter
55
Input Jam
the Flipper on time.
[Changer] Card
A card is jammed in the
56
Output Jam
Flipper.
An abnormal card is
[Changer] Card
57
found in the Flipper.
Exist
⑤ Miscellaneous
Code
Code Name
Description
15
Media Error
The media error
occurs.
An EEPROM read/
16
EEPROM Error
write error occurs.
Solution
Check the Ribbon and Ribbon
encoder status.
Solution
Repair service is required.
Turn off → Remove any cards →
Reboot
Turn off → Remove any cards →
Reboot
Turn off → Remove any cards →
Reboot
Turn off → Remove any cards →
Reboot
Turn off → Remove any cards →
Reboot
Turn off → Remove any cards →
Reboot
Turn off → Remove any cards →
Reboot
Turn off → Remove any cards →
Reboot
Solution
Check the card (media) and
path sensor status.
Reboot or replace the EEPROM.
81
JAVELIN DNA User Guide Manual