GB
Care and maintenance
GB
IE
IE
General cleaning
> Check for worn or damaged parts. Replace worn parts as necessary or contact
an authorised service centre for repair before using the product again.
Maintenance
Before and after each use, check the product and accessories (or attachments)
for wear and damage. If required, exchange them for new ones as described in
this instruction manual. Observe the technical requirements.
Power cord
If the supply cord of this power tool is damaged, it must be replaced by a specially
prepared cord available through the service organization.
UK plug
If you need to replace the fitted plug, then follow the instructions belo .
IMPORTANT: The wires in the mains lead are coloured in accordance with the
following code:
Blue – Neutral Brown – Live
As the colours of the wire in the mains lead of this product may not correspond
with the coloured marking identifying the terminals in your plug, proceed as
follows. The wire, which is coloured blue, must be connected to the terminal,
which is marked with N or coloured black. The wire, which is coloured brown,
must be connected to the terminal, which is marked L or coloured red.
28
Connect
Blue to
N(Neutral)
Outer sleeve
firmly clampe
TTB877DRH by TITAN
10
AMP fuse
approved to
BS 1362
Brown L(Live)
Cable grip