Table of Contents
Advertisement
GB
Operation
GB
IE
IE
Drilling
General drilling
WARNING! During operation fine dust will be generated
Some dusts are highly inflammable and explosive! Do not smoke
during operation, keep heat sources and open flames out of the
working area!
Always wear a dust mask to protect yourself against hazards resulting
from fine dust
> Always hold the product perpendicular to the point to be drilled. Holding it at an
angle may cause slipping or jamming of the drill bit.
> Always place the drill tip directly on the point to be drilled first and then switch
the product on.
> Pre-drill larger holes with a small diameter drill bit first. Doing so makes drilling
with larger diameter drill bits easier.
WARNING! Switch the product off, let it come to a complete stop and
disconnect it from the power supply if the attachment gets stuck in the
workpiece. Only then free the jammed attachment.
Hammer drilling mode
Use this function to drill holes in masonry.
NOTE: In principle, drill masonry in the hammer drilling operation
mode. However, in the first few seconds of operation, the drill bit may
deviate from the original desired position due to the hammer action.
To avoid this, turn the hammer function off and pre-drill the hole in the
drilling mode.
> Set the mode selector to the correct position.
> Insert a suitable drill bit.
26
TTB877DRH by TITAN
Advertisement
Table of Contents
