Table of Contents
Advertisement
TTB877DRH by TITAN
Drilling mode
Use this function to drill holes into wood, wood similar materials, plastic or metal.
> Set the mode selector to the correct position.
> Insert a suitable drill bit. Punch the drilling point before operation in order to
avoid slipping of the drill bit.
> Use a metal drill bit for drilling into plastic and metal. Where necessary use a
cooling lubricant that is available at your specialist dealer.
After use
> Switch the product off, disconnect it from the power supply and let it cool down.
> Check, clean and store the product as described below.
The golden rules for care
WARNING! Always switch the product off, disconnect the product from
the power supply and let the product cool down before performing
inspection, maintenance and cleaning work!
> Keep the product clean. Remove debris from it after each use and before
storage.
> Regular and proper cleaning will help ensure safe use and prolong the life of
the product.
> Inspect the product before each use for worn and damaged parts. Do not
operate it if you find broken and worn parts
WARNING! Only perform repairs and maintenance work according to
these instructions! All further works must be performed by a qualified
specialist!
General cleaning
> Clean the product with a dry cloth. Use a brush for areas that are hard to reach.
> In particular clean the air vents (7) after every use with a cloth and brush.
> Remove stubborn dirt with high pressure air (max. 3 bar).
NOTE: Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be
harmful to its surfaces.
Operation / Care and maintenance
GB
GB
IE
IE
27
Advertisement
Table of Contents
