Remote Control - A-Neuvideo ANI-PiP-41UHD Instruction Manual

Remote Control

q POWER ON OR STANDBY:
power on the switcher or set it to standby mode.
w HD 1/2/3/4:
Press these buttons to select input
source on single screen display mode, and the
corresponding input LED on the front panel will light
in green.
t u: Press these buttons to circularly select the last
or next input source on single screen display mode.
: Multiview display mode switching button.
▪ Press this button to circularly select: SINGLE - PIP
- PBP (1) - PBP (2) - Triple (1) - Triple (2) - Quad (1)
- Quad (2).
▪ Hold this button for 3 seconds to select the aspect
ratio for PBP (1) / PBP (2) / Triple (1) / Triple (2) / Quad
(1) / Quad (2).
RES: Output resolution switching button.
▪ Press the RES button to circularly switch the output resolution of the HDMI OUTPUT port
(Please refer to the output resolution list of "8. Video & Audio").
▪ Hold the RES button for 3 seconds to switch the output resolution to 720P60.
e MENU, EXIT, LEFT, RIGHT, UP, DOWN, OK:
r A-IN:
Press this button to pop up the audio channel selection OSD, then press the UP
/ DOWN button to select the audio output channel. (The output audio follows the video
source by default.)
Mute: Press this button to mute / unmute the audio.
VOL-, VOL+: Press these buttons to increase / decrease the audio output volume.
Power Toggle
HD Input 1
HD Input 2
HD Input 3
HD Input 4
Previous Source
Next Source
Press this button to
08F7 4D Cycle Multiview
08F7 09 Resolution
08F7 54 Menu
08F7 47 Exit
08F7 42 Menu Up
08F7 08 Menu Left
08F7 48 Menu Right
OSD Menu navigation buttons.
08F7 4B
08F7 43
08F7 55
08F7 40
08F7 4E
08F7 0D
08F7 16
7
OK 08F7 56
A-In 08F7 13
Mute 08F7 12
Volume + 08F7 15
Volume - 08F7 53