Remote Control - A-Neuvideo ANI-PiP-41UHD Instruction Manual

Remote Control

q POWER ON OR STANDBY:
Press this button to
power on the switcher or set it to standby mode.
w HD 1/2/3/4:
Press these buttons to select input
source on single screen display mode, and the
corresponding input LED on the front panel will light
in green.
t u: Press these buttons to circularly select the last
or next input source on single screen display mode.
: Multiview display mode switching button.
▪ Press this button to circularly select: SINGLE - PIP
- PBP (1) - PBP (2) - Triple (1) - Triple (2) - Quad (1)
- Quad (2).
▪ Hold this button for 3 seconds to select the aspect
ratio for PBP (1) / PBP (2) / Triple (1) / Triple (2) / Quad
(1) / Quad (2).
RES: Output resolution switching button.
▪ Press the RES button to circularly switch the output resolution of the HDMI OUTPUT port
(Please refer to the output resolution list of "8. Video & Audio").
▪ Hold the RES button for 3 seconds to switch the output resolution to 720P60.
e MENU, EXIT, LEFT, RIGHT, UP, DOWN, OK: OSD Menu navigation buttons.
r A-IN:
Press this button to pop up the audio channel selection OSD, then press the UP
/ DOWN button to select the audio output channel. (The output audio follows the video
source by default.)
Mute: Press this button to mute / unmute the audio.
VOL-, VOL+: Press these buttons to increase / decrease the audio output volume.
7