Pepperl+Fuchs OBD30M-R2000-4EP Manual page 19

2-d laser scanner

Hide thumbs Also See for OBD30M-R2000-4EP:

Table of Contents

2-D Laser Scanner

Commissioning

DHCP

Set the device to DHCP under the "Address mode" menu item. The DHCP config-

uration requires a DHCP server in the local network, e.g., a router. See the "Auto

IP" item for information on this.

Manual IP

Set the device to manual under the "Address mode" menu item. The IP address is

set to 10.0.10.9 and the subnet mask to 255.0.0.0 by default. To connect the

device to the PC, the network card must be configured as follows.

Set the required IP address in the network card menu. Select the TCP/IP protocol

in the network card properties and select the "Use the following IP address" set-

ting there. Enter the required IP address and subnet mask.

Table of Contents