Installation Location Requirement Of Outdoor Unit - Samsung EHS AE050RXYDEG/EU Manual

1. Safety precaution

1.6 Installation location requirement of outdoor unit

• Wear protective gloves to unpack, move, install, and service the unit to avoid your hands being injured by the edge of
the parts.
• Do not touch the internal parts (water pipes, refrigerant pipes, heat exchangers, etc.) while running the units. And
if you need to adjust and touch the units, please observe enough time for the unit to cool down and wear protective
gloves.
• In case of refrigerant leakage, try to avoid getting in contact with the refrigerant because this could result in severe
wounds.
• When you install the air to water heat pump in a small room, you must consider proper ventilation to prevent a
leakage level within the maximum permissible limit.
– As refrigerant is heavier than air, it may lead to suffocation by absence of oxygen.
– Make sure to safely dispose of packing materials. Packing materials, such as nails and other metal or wooden
pallets may cause injuries to humans and animals by unsafe disposal.
– Our units shall be installed in compliance with the spaces described in the installation manual, to ensure
accessibility from both sides and allow repairs or maintenance operations to be carried out. If the units installed
without complying with procedures described in manual, additional expenses can be asked because special
harnesses, ladders, scaffolding or any other elevation system for repair service will not be considered part of the
warranty and will be charged to the end customer.
• Make sure that (thaw) water runs correctly and unhindered out of the unit at low ambient temperature. If the
drainage is exposed to subzero temperatures, additional protection must be taken by the installer, such as installing
heater cables in the drain piping. Failing to do so, may cause severe damage to the product and potential leakages of
refrigerant into the environment.
• Install the power cable and communication cable of the indoor and outdoor unit at least 1m away from other electric
appliances.
• Protect the unit from rats or small animals. If an animal makes contact with the electric parts, it can cause
malfunctions, smoke or fire. Please instruct the customer to keep the area around the unit clean.
• Do not disassemble and alter the heater at your own discretion.
• Wear protective equipment (such as safety gloves, goggles, and headgear) during installation and maintenance works.
• If the installation/repair technicians not be equipped by protective equipment injure or threat may happen.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
the appliance use by a person responsible for their safety. Children should be supervised to ensure they do not play
with the appliance.
• Oil shall be drained safely from the system.
• To prevent ignition, never install motor-driven equipment close to the unit.
• Empty recovery cylinders shall be evacuated and cooled before recovery.
• The applicable local, National, and European regulations shall be observed.
Installer reference guide / Mono tank integrated type 11