We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY (877-907-
8669).
STEP 6:
Remove 4 Screws (No. 64) from the Meter (No.
46) using Spanner (No. 75).
Pull the Meter Wire A (No. 46a) and Meter Wire
B (No. 46b) through the Support Plate (No. 6),
then lock the Meter (No. 46) and Tablet Holder
(No. 96) to the Support Plate (No. 6) with 4
Screws (No. 64) that were just removed.
Tighten and secure with Spanner (No. 75).
Connect the Sensor Wire A (No. 93a) to the
Meter Wire B (No. 46b), connect the Sensor
Wire B (No. 93b) to the Meter Wire A (No.
46a).
Attach Support Plate (No. 6) to Sensor Stand
(No. 5) using 1 Bolt (No. 63), 2 Washers (No.
71), and 1 Nylon Lock Nut (No. 56). Tighten
with Allen Wrench (No. 74) and Spanner (No.
75).
Make sure it is not too tight to adjust the angle
of Meter (No. 46).
The assembly is complete!
7