NEC e808y Product Manual page 55

e808 Settings
To
1 Check cable connection
2 Turn e808 power on
3 Select External Connect
PC Settings
To
1 Connect to the Internet
2 Start the Internet communication
Useful Tips
• For your PC, e808 is used as a "modem".
• Enter "✱99#" for an access point number (APN). If service conditions are changed, use the AT
commands to change the APN. In this case, use a terminal software that supports AT commands (e.g.
Hyperterminal).Open a Hyperterminal screen, and input the AT command to set the APN in the following
format:
AT+CGDCONT=1, "IP", "APN".
"IP": Input as shown.
"APN": Place the access point number inside " ".
For example, when you want to set an APN of aaa.bbb.ccc, input:
AT+CGDCONT=1, "IP", "aaa.bbb.ccc".
After inputting the command, press the Return key. If OK is displayed, the APN setting is completed.
To confirm the current APN setting, input AT+CGDCONT?.
Advanced Features
Do this
Check the cable connection between PC and e808.
Refer to Power On/Off on page 11 for details.
Press the MENU key and select External Connect.
Network connection standby screen is displayed.
Do this
Double-click the dial-up network icon.
Note : The dial-up network icon can be created by the Network
Connection Wizard: follow the dialogue to set required
information (Username, password, IP address, access
point number, etc.).
After connection is made, start up and use the appropriate
Internet application (browser, mailer, instant messenger, etc.).
-45-