Usb - NEC e606 Product Manual

USB

Connecting e606 to a PC with an USB cable enables the PC to use e606 just like the modem to establish a
PPP connection to the Internet service provider by dialup. However, you will find that the USB connection will
provide a much faster transfer rate than a standard modem.
USB connection also enables data transfer to and from the PC. Refer to To/From PC on page 123 for
details.
To Establish a Dialup Connection for a PC with an USB Cable
To
1 Connect e606 and the PC with
a USB cable.
2 Start up the external connection
function
3 Put e606 in the standby mode for
USB
4 Dial up
5 Disconnect
Do this
Insert the USB cable to the I/O connector of e606 and the USB
hub on the PC.
Note : Use the USB cable attached to e606.
Note : Insert the USB cable vertically to e606 (do not insert it at
an angle).
Press the MENU key and select External Connect.
Select USB.
Network connection standby screen is displayed.
From the PC application, start the dialup.
Disconnect from the PC application.
-62-
External Connect