To Copy And Paste The Text - NEC e606 Product Manual

To Change to Insert/Overwrite Mode
To change to insert/overwrite mode, press the SK2 (Submenu) key in the text input mode, then select Insert
or Overwrite.
In the Insert Mode, you can insert characters at the cursor position.
In the Overwrite Mode, you can overwrite characters starting at the cursor position.
To Change to Delete/Backspace Mode
To change to delete/backspace mode, press the SK2 (Submenu) key in the text input mode, then select
Delete or Backspace.
In the Delete Mode, you can delete characters after the cursor by pressing the C key. Pressing and holding
the C key deletes all the characters after the cursor.
In the Backspace Mode, you can delete characters before the cursor by pressing the C key. Pressing and
holding the C key deletes all the characters before the cursor.

To Copy and Paste the Text

To copy and paste text, proceed as described below:
To
1 Specify the copy function
2 Specify the copy starting point
3 Specify the copy ending point
4 Specify the paste point
Text Entry
Do this
Press the SK2 (Submenu) key in the text input mode, then
select Copy.
Move the cursor to the starting point of the block to copy by
using the Up, Down, Left, or Right key and press the Enter
key.
Note : You can cancel the specified copy starting point by
pressing the C key.
Move the cursor to the ending point of the block to copy by
using the Up, Down, Left, or Right key and press the Enter
key.
Note : A maximum of 512 characters can be copied.
Move the cursor to the paste point by using the Up, Down,
Left, or Right key.
-27-