Ptz; Default - Eclipse Security ECL-IP3D50MV Manual

5.5.3 PTZ

Please note only some series products support this function.
The PTZ interface is shown as in
Please refer to the following sheet for detailed information.
Parameter Function
Protocol
Address
Baud
Rate
Data Bit
Stop bit
Parity

5.5.4 Default

The default setup interface is shown as in
Please note system cannot restore some information such as network IP address.
Figure 5-
Select the corresponding dome protocol.
Set corresponding dome address. Default value is 1.
Please note your setup here shall comply with your dome address;
otherwise you can not control the speed dome.
Select the dome baud rate. Default setup is 9600.
Default setup is 8.
Default setup is 1.
Default setup is none.
Figure 5-
70.
Figure 5- 70
71.
82