Pre Start Inspection; Safety Instructions - Sakai R2-4 Shop Manual

• Observe all safety instructions and warnings attached to the machine.
• Make sure all safety instructions and warnings on the machine are complete and perfectly
legible.
• Stop the machine immediately in the event of any malfunction. Report any malfunction
immediately to the supervisor or other person of authority.
• Never perform service or maintenance on the machine unless the drums or tires are
adequately blocked, articulation lock bar and pin is in the locked position and the parking
brake is applied.
• Never make any modifications to the machine which might affect safety without the
manufacturer's approval.
• Always perform the recommended routine inspections and adjustments according to the
prescribed intervals.

1-5. Pre Start Inspection

• Inspect your machine daily. Ensure that the routine maintenance and lubrication are properly
performed. Repair or replace any malfunctioning, broken or missing parts before using the
machine. Refer to the maintenance schedule in the Operator's Manual.
• Check that all instructions and safety stickers are in place and readable.
• Never fill the fuel tank with the engine running or while near an open flame or while smoking.
• Always clean up any spilled fuel.
• Check for any warning tags placed on the machine, do not operate the machine until all
repairs have been made and warning tags have been removed by authorized personnel.
• Check the seat belt for wear or damage; inspect the belt hardware and fabric. Replace
if hardware is damaged or the belt is frayed or nicked or stitching is loose. Check that
mounting hardware is tight.
• Clean the steps and operating platform of dirt and foreign matter to reduce danger of
slipping.
• Know how to shut-down or stop the machine immediately in case of emergency.
• Know the capabilities and limitations of the machine such as speed, gradeability, steering
and braking.
• Be aware of the dimensions of the machine such as height, weight especially for
transporting.

1-6. Safety Instructions

• Take all necessary precautions to ensure that the machine is used only when in a safe and
reliable condition.
• Avoid any operational mode that might compromise safety.
• Operate the machine only if all protective and safety devices are in place and fully
functional.
• Always use the hand rails and steps to get on and off your machine maintaining 3-point
contact (using both hands).
SAFETY
1-003