Example Listing Of P/C Card Failure Class; Result Of Function - Siemens SIMATIC VPU200/560 Programming Manual

Function 27: Function 27 (P/C Card Failure Class) allows you to specify
whether or not failure of a particular board (card) will cause the system to
fail. After selecting Function 27 from the menu, a display listing the P/C
slot, type of board, and failure class, appears as shown in Figure 9-6.
Figure 9-6 Example Listing of P/C Card Failure Class
The card failure class listing will only show slot numbers that contain
boards. To change the class of a board use the UP/DOWN arrow keys to
position the cursor in the failure class field for the board to be changed. Use
the F2 key to change the failure class field from "FATAL" to "NON-FATAL"
or vice versa. After F2 is pressed, the displayed failure class of the board
will change to the new class. Some boards must be classed as "FATAL," and
cannot be changed. If a change is made to one of these the message,
"INVALID DATA SENT WITH COMMAND," is displayed.
Function 29: Function 29 "Show P/C Diagnostic Cell") will obtain the
diagnostic cell from the P/C. The function will then display the cell on the
screen in the form shown in Figure 9-7.
Figure 9-7 Result of Function 29
SIMATIC VPU200/560 Programming Manual Using VPU200 Support Functions 9-11