Maintenance; Troubleshooting - Hyundai 35701 Instruction Manual

INSTRUCTION
Start the grass brimmer before getting close to the grass to be cut.
Cut the grass by moving the grass trimmer from right to left and proceed slowly keeping the trim-
mer inclined by about 30º (Fig. E ).
High grass should be cut in layers , always beginning from the top. The cuts should be short
(Fig.D)
Do not cut damp or wet grass. Dry grass will give excellent results.
Always let the nylon wire rotate at top speed; do not work in such a way as to overload the trim-
mer.
Caution! Do not use the Grass Trimmer without the guard.
Never pass the grass trimmer over the extension cable while the grass rimmer is running; make
sure it is always in a safe position behind your back.
Before starting work, make sure that the area to be cut is free of stones, debris, wires and any
other objects.

Maintenance

Befor carrying out any maintenance operations,cut off the electric power supply by disconnecting
the plug from the extension cable.
Regular cleaning and maintenance of you grass trimmer will ensure efficiency and prolong the life
of your machine.
After each cutting operation, take apart and clean out the grass and soil from; the spool and its
slot, the whole trimmer and in particular the guard.
During operation, keep the air solts clean and free of grass.
Only use a cloth soaked with hot water and a soft brush to clean the grass trimmer.
Do not spray or wet the appliance with water.
Do not use detergents or solvents as these could ruin the trimmer. The parts in plastic can easily
be damaged by chemical agents.
If the wire cutting blade no longer cuts or breaks, have this replaced by contacting an authorized
service center.
CAUTION! The blade can give deep cuts.
For repairs which have not been explained in these instructions, contact an authorized service
center.
Trouble-Shooting
CAUTION! Befor every operation disconnect the leectric power supply!
If the grass trimmer vibrates: remove the spool and clean its slot carefully removing any grass and
so forth. If vibration persists after reassembly, replace the spool with a new one . In the evert of the
problem not disappearing , have the trimmer checked at an authorized service center.
If the grass trimmer does not start: check all the electrical connections; make sure the safety
circuit-breaker has not been activated; check that no fuse has blown in your leectrical system. If
after the above checks, the grass trimmer still dose not start, have it checked at an authorized
service center.
ENGLISH
24