Electrical Requirements; Person Protection - Hyundai 35701 Instruction Manual

20.Disconnect the supply(by pulling out the plug from the socket for example):
Always, when the machine is without supervision
Before eliminating of blocking
Before checking cleaning or work on the machine
After crash into another subject
Always when the machine begins vibrate unreasonably

ELECTRICAL REQUIREMENTS

1.Connect the device only on the plug with a protective device to prevent stray current(FI switch)
with a rated fault current of not more than 30 mA
2.Use Only extension cords approved for outdoor use with adequate protection against splashing
water Cross strands extension cord should be for cords up to 25m at Least 1.5mm2 and for cords
exceeding 25m min 2.5mm2
3.Cable drum before using completely unwind Make sure the cord is not damaged
Caution! Do not touch the damaged cable and pull the mains plug when the cable is damaged
while working Damaged cables increase the risk of an electric shock If the power supply is dam-
aged, it must be immediately replaced with a cable without defect, to avoid dangerous situations
Note Check with your local Electricity Board or electrician if in doubt whether your house service
connection meets these requirements
1.Position power supply cable so it does not interfere with the work and is not damaged
2.Protect power supply cable from heat corrosive Liquids and sharp edges
3.Use only rubber-jacketed extension cords with sufficient wire gauge
4.Do not manipulate the machine by service cable, do not pull up the socket inlet from the socket
outlet by pulling the service cabeI Protect the service cable against heat, grease and sharp edges
5.Pull up the socket inlet from the socket outlet before every adjustment, repair or maintenance
6.Check the service cabal regularly and check if there are not marks of damage or ageing
7.This electric device is constructed in accordance with all valid safety regulations, which relate
to it All repairs must be made only by qualified persons and and only original spare parts can be
used It can come to serious danger for the user in another case

PERSON PROTECTION

Be prepared! Have about one following things at least
1. Suitable fire extinguisher (e.g. CO2 or Dry Powder)
2. Fully equipped first-aid kit, available easily for machine operator and accompanying person
3. Clean towels and clothes for angiotrispsia.
4. Mobile phone or another device for quick calling of rescue service
Don't work alone There must be around another person who knows principles of the first aid
The accompanying person must keep safe separation distance from your workplace, but he/she
must be able to see you the whole time! Work only on such places where you are able to call the
rescue service quickly!
Put safety first in the case of fire
INSTRUCTION
ENGLISH
21