Table of Contents
Advertisement
Electrical Safety Rules
⚫ The mains voltage must correspond to the one marked on the
technical data plate (230V～50Hz).Do not use other sources of
power.
⚫ Appliance should be supplied via a residual current device (RCD) with
a tripping current of not more than 30 mA.
⚫ Never pass the grass trimmer over the extension cable which the
grass trimmer is working as this could cut the cable .Mark sure you
always know where the cable is.
⚫ Use the special cable holder for the connection of the extension
cable .
⚫ Never use the trimmer when it is raining , Try to prevent it from
getting wet or being exposed to humidity, Do not leave it outside
overnight. Do not cut damp or wet grass.
⚫ The power supply cable should be checked regularly and before suing
in each time make sure the cable is not damaged or old out. If the
cable is not in good condition , do not use the trimmer. Take it to an
authorized service center instead.
⚫ Only use an extension cable which is suitable for outdoor work Keep
it away from the cutting area,from damp,wet or oily surfaces or with
sharp edges and away from heat and fuels.
⚫ The mobile socket of the extension cable should be splash proof in
compliance with DIN 57282 and DIN VDE 0282 regulations; the
cross-section of the wire (max. length 75m) should be at least 1.5mm
².Use H07RN-F harmonized cable.
⚫ This grass trimmer has been built with dual insulation in compliance
with EEC 20 regulations. Dual insulation is electrically safer and
therefore the trimmer need not earthing.
⚫ Be familiar with the controls and proper use of the equipment;
⚫ – Before use check the supply and extension cord for signs of damage
or ageing,
⚫ – If the cord becomes damaged during use, disconnect the cord from
the supply immediately.
Advertisement
Table of Contents
