Use - Vitrifrigo FG Series Installation Use And Assistance Manual

Refrigerators for milk storage
Hide thumbs Also See for FG Series:
Table of Contents

Advertisement

7.4

Use

The FG10I DGT, FG10I DGT CHILL&CW refrigerator has a hole on each side for ducting the pipe to
pick up milk from the container placed inside the refrigerator.
NOTE: apply the dedicate transparent cap on the not used hole.
The refrigerator must be used only with the provided tank, in any case with closed milk containers.
The refrigerator is provided of a digital thermostat placed on the frontal panel.
Refrigerator switch on
When the refrigerator is switched on, but in standby mode, the thermostat's display shows
alternatively "OFF" and the inside temperature value.
To turn on the refrigerator, hold the button
the display and immediately after the inside temperature value.
NOTE: every time the refrigerator turn ON, also the cup warmer shelf turn ON.
Once turned on, the fridge will start working, but it will take some time (also depending on external
conditions) to reach the required internal temperature.
We recommended to put milk inside the refrigerator only when the internal temperature has
stabilized to the required value.
Temperature setting
To set the desired temperature, push the button
flashing, then adjust the value using the button
the new value press again the button
NOTE: To ensure that the milk is always maintained at temperature allowed by the HACCP, the
setpoint can be varied only within a specific values range.
NOTE: The refrigerator can operate at inferior temperatures than the level obtained, by setting the
thermostat to lower setpoint values. However, since these temperatures are out of the
envisaged range for storing milk or similar liquids for human consumption, the manufacturer
advises against using the refrigerator in this way, stressing again that the appliance is
designed and made to store milk or similar liquids for human consumption at a controlled
temperature and not to chill such products from room temperature.
pushed for at least 3 seconds. You will see "ON" on
until you see the current set point value
(to increase) and
.
23
(to decrease); to store
EN

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fg10i dgtFg10i dgt chill&cw

Table of Contents