Siemens SIMATIC ET 200SP Manual page 62

Input delay for digital inputs
Select level for DI
Edge selection for DI
Frequency of
synchronization
Count direction for synchroniza-
tion
Set output
Comparison value 0
Comparison value 1
Count direction of DQ function
Pulse duration
Hysteresis (in increments)
Because the number of parameters is limited to a maximum of 244 bytes per station in the
1
PROFIBUS GSD configuration, the possible parameter assignments are limited. The parameters
are preassigned default settings in the module. If your PROFIBUS master supports the "Write/read
data record" function, you can set these parameters using data record 128.
When a GSD file is used, this diagnostic interrupt is enabled with the "Enable additional diagnostic
2
interrupts" parameter and is then not separately configurable.
TM Count 1x24V (6ES7138‑6AA01‑0BA0) technology module
Manual, 07/2019, A5E33002339-AD
Parameter
1
•
•
•
•
•
•
•
•
•
1
•
•
1
•
•
•
1
•
•
•
•
•
•
•
•
•
0...33554431
1
0...10...33554431
1
1
•
•
•
0...500.0...6553.5 ms
1
0...255
1
Value range
None
0.05 ms
0.1 ms
0.4 ms
0.8 ms
1.6 ms
3.2 ms
12.8 ms
20 ms
Active with high level
Active with low level
At rising edge
At falling edge
Once
Periodic
Up
Down
In both directions
Between comparison value and high limit
Between comparison value and low limit
Between comparison value 0 and 1
At comparison value for a pulse duration
Digital output without function
Up
Down
In both directions
Configuring/address space
4.4 Fast Mode
Scope
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
61