Address Space - Siemens SIMATIC ET 200SP Manual

Configuring/address space
4.3 Manual operation (without technology object)
4.3.4

Address space

Address space of the technology module
Table 4- 9
Range
4.3.5 Control and feedback interface
Note
The control and feedback interface is compatible with the control and feedback interface of
the TM Count 2x24V, TM PosInput 2 and TM PosInput 1 technology modules of the S7-1500
automation system.
4.3.5.1 Assignment of the control interface
The user program uses the control interface to influence the behavior of the technology
module.
Control interface
The following table shows the assignment of the control interface:
Byte
offset
Bit 7
from
start
address
↓
0...3
4...7
8
9 EN_
CAPTURE
10 SET_DIR
11
46
Size of input and output addresses of the TM Count 1x24V with manual operation
Bit 6 Bit 5
DINT or REAL: Load value (meaning of the value is specified in LD_SLOT_0)
Value range: –2147483648 to 2147483647
DINT or REAL: Load value (meaning of the value is specified in LD_SLOT_1)
Value range: –2147483648 to 2147483647
LD_SLOT_1
EN_ EN_
SYNC_DN SYNC_UP
Inputs
16 bytes
Bit 4 Bit 3
SLOT_0:
or 80000000 to 7FFFFFFF
D
SLOT_1:
or 80000000 to 7FFFFFFF
D
SET_DQ1 SET_DQ0
Reserved
Reserved
TM Count 1x24V (6ES7138‑6AA01‑0BA0) technology module
Outputs
12 bytes
Bit 2 Bit 1
H
H
LD_SLOT_0
TM_ TM_
CTRL_DQ1 CTRL_DQ0
RES_
EVENT
Manual, 07/2019, A5E33002339-AD
Bit 0
SW_GATE
RES_
ERROR