Parameter Setting - Siemens SIMATIC ET 200SP Manual

Configuring/address space
4.2 Position input for ""Motion Control"" technology object
4.2.2

Parameter setting

You specify the properties of the technology module using various parameters. Depending
on the settings, not all parameters are available.
You set the parameters of the module as follows in this operating mode:
1. Insert the module from the hardware catalog under "Technology modules".
2. Set the operating mode "Position input for technology object "Motion Control"" and the
other module parameters in the hardware configuration.
3. Insert the axis technology object and, if necessary, the measuring input technology object
from the project tree in folder "Technology objects > Add new object > Motion Control".
You can find information on configuring with axis technology objects in function manual
S7-1500T Motion Control
(https://support.industry.siemens.com/cs/ww/en/view/109481326).
4. Open the configuration of the axis technology object, e.g. using the Configuration button
5. Set the parameters of the technology objects.
6. Download the project to the CPU.
Parameters of the TM Count 1x24V
The following parameter settings are possible. The default settings of the parameters are
shown in bold in the "Value range" column.
Table 4- 5
Potential group
Signal type
Invert direction
(counter inputs)
Signal evaluation
for counter inputs
34
in the respective instruction for the technology object.
Configurable parameters
Parameter Value range
Use potential group of the left module (dark
•
BaseUnit)
Enable new potential group (light BaseUnit)
•
Pulse (A)
•
Pulse (A) and direction (B)
•
Count up (A), count down (B)
•
Incremental encoder (A, B phase-shifted)
•
Incremental encoder (A, B, N)
•
Deactivated
•
Activated
•
Single
•
Double
•
Quadruple
•
TM Count 1x24V (6ES7138‑6AA01‑0BA0) technology module
Scope
Module
Channel
Channel
Channel
Manual, 07/2019, A5E33002339-AD