Parameter Setting - Siemens SIMATIC ET 200SP Manual

4.3.3

Parameter setting

You specify the properties of the technology module using various parameters. Depending
on the settings, not all parameters are available. When parameters are assigned in the user
program, the parameters are transferred to the module with the "WRREC" instruction and
data record 128 (Page 92).
You set the parameters of the module as follows in this operating mode:
Parameter setting using...
Hardware configuration in STEP 7
(TIA Portal)
Hardware configuration in STEP 7
with HSP
Hardware configuration with GSD
file for distributed operation on
PROFINET IO
Hardware configuration with GSD
file for distributed operation on
PROFIBUS DP
TM Count 1x24V (6ES7138‑6AA01‑0BA0) technology module
Manual, 07/2019, A5E33002339-AD
Basic procedure
1. Insert the module from the hardware catalog under "Technology modules".
2. Set the operating mode "Manual operation (without technology object) " and the
other module parameters in the hardware configuration.
3. Download the project to the CPU.
1. Install the appropriate HSP file.
You will then find the module in the hardware catalog under "ET 200SP".
2. Set the device configuration and the parameters in the hardware configuration.
3. Download the project to the CPU.
1. Install the current PROFINET GSD file.
You will then find the module in the hardware catalog under "Other field devices >
PROFINET IO > I/O".
2. Set the parameters in the hardware configuration.
You can find information on the respective dependencies of the parameters in
function manual Counting, Measurement and Position Detection
(http://support.automation.siemens.com/WW/view/en/59709820).
3. Download the project to the CPU.
1. Install the current PROFIBUS GSD file.
You will then find the module in the hardware catalog under "Other field devices >
PROFIBUS DP > I/O".
2. Set the parameters in the hardware configuration.
You can find information on the respective dependencies of the parameters in
function manual Counting, Measurement and Position Detection
(http://support.automation.siemens.com/WW/view/en/59709820). The parameters
marked with in the following tables are not configurable in the PROFIBUS GSD
1
file.
3. Download the project to the CPU.
The parameters marked with
default setting.
4. If necessary, set the parameters marked with
record 128.
Configuring/address space
4.3 Manual operation (without technology object)
in the following tables are downloaded with their
1
in the user program using data
1
41