Multitech MTASR3-200 Quick Start Manual page 8

RASFinder MTASR3-200 Quick Start Guide
4. Connect one end of the power supply to a live AC outlet
and connect the other end to the RASFinder as shown in
Figure 3. The power connector is a 6-pin circular DIN
connector.
5. Turn on power to the RASFinder by setting the backpanel
ON/OFF switch to the ON position. Wait for the Fail LED
on the RASFinder to go OFF before proceeding. This may
take a couple of minutes to go OFF.
At this time your RASFinder is completely cabled and
powered on.
Proceed to the next section to install the RASFinder software.
8