Installing The Dishwasher - Hanseatic HGTI6082C147735TS User Manual

Fire hazard!
Improper handling of the appliance
can lead to fire.
■ Never use multi-socket adapters, mul-
ti-socket strips, travel adapters or the
like.
Depending on the location the dishwasher
must be connected before or after assembly/
installation.
– For the electrical connection of the dish-
washer, a professional must install an
earthed power socket with its own fuse of
a sufficient size (see "Technical specifica-
tions" on page EN-42).
– The plug must be installed in such a way
that the recess into which the dishwasher
will be fitted is deep enough even when the
plug is plugged in.
– Do not use a multi-socket extension cable,
multi-socket plug, travel adapter, extension
cable or similar.
– We recommend using a pulse-sensitive re-
sidual current device (RCD).
• Connect the mains plug to a properly in-
stalled socket with an earthing contact

Installing the dishwasher

NOTICE
Risk of damage to property!
Selecting the wrong screws can dam-
age the worktop.
■ Use the supplied countersunk screws
or screws of the appropriate length.
• Only install the dishwasher underneath a
continuous worktop which is joined to the
units adjacent to the dishwasher.
Set-up, connection and initial start-up
• Maintain sufficient distance from the walls
and adjacent appliances. The meas-
urements of the recess must at least
correspond to the details in the diagram
page EN-29.
1. Switch the fuse off.
2. Remove cardboard, polystyrene and ad-
hesive strips from the inside of the dish-
washer, if you have not already done so.
3. Affix the enclosed protective film (c) to the
bottom of the worktop. In this way, you will
avoid damage to the worktop as a result
of hot steam which may be emitted from
the dishwasher if the dishwasher door is
left open.
(e)
4. Insert the two mounting brackets (e) into
the front slots on the top of the dishwash-
er so that you can screw the dishwasher
to the worktop subsequently.
Page EN-31
(c)