Signal Tones; Display; Selecting Programme And Starting The Programme Run; Programme End - Hanseatic HGTI6082C147735TS User Manual

Signal tones

The appliance sounds a signal tone when
sensors are touched. This tells you that the
appliance has understood your action.
The appliance will make eight signal tones
when the programme has ended.
If you pause a programme run for an extend-
ed period, a signal tone sounds to remind you
to continue the programme run.

Display

The display informs you of the current status
before, during and after the programme run.
To save energy the display switches off while
the programme is running. To switch the light-
ing back on, briefly touch the sensor
Selecting programme and
starting the programme run
It is recommended that you carry out a
test run before the first dishwasher
cycle in order to remove residues from the
manufacturing process and in order to en-
sure that the appliance functions perfectly.
Carry out this test run when the dishwasher
is empty and without any dishwasher deter-
gent.
1. Select the suitable dishwashing pro-
gramme based on the "programme table",
see page EN-21.
2. Touch the sensor P (2) until the symbol of
the desired programme lights up.
3. Touch the sensor
programme.
During the programme run:
– the bars at the bottom of the display (5)
indicate which of the four sub-pro-
grammes are currently running (pre-
rinse, main wash, rinse, dry)
– the two dots in the remaining time dis-
play (14) flash
– the display switches off to save energy.
The programme continues.
4. Once the programme has finished, a sig-
nal tone will sound and the LED next to
the programme symbol will stop flashing.
5. Now turn off the water tap and touch the
sensor (1) to switch the dishwasher off.
6. Continue with "Unloading the dishwasher"
on page EN-24.
(9).

Programme end

During the drying phase (except for pre-rinse
programme):
– the door opens automatically for the steam
to escape.
– 8 signal tones will sound and the display (5)
will show
End.
1. Touch the sensor
washer off.
2. Turn the tap off.
3. Continue with "Unloading the dishwasher"
on page EN-24.
If no further settings are made, the appliance
will automatically switch off/enter standby
mode after 15 minutes.
Operation Page EN-23
(9) to start the wash
(1) to switch the dish-