Automatic Regeneration; Test Run - Hanseatic HGTI6082C147735TS User Manual

Semi integrated dishwasher / build under dishwasher
Hide thumbs Also See for HGTI6082C147735TS:
Table of Contents

Advertisement

Available languages

Available languages

Degree of
household water
hardness
1. Obtain the appropriate setting from the
table above.
2. Close the dishwasher door.
3. If the dishwasher is switched on, touch
the sensor
(1) to switch it off.
Adjusting the water hardness
level
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Switch the dishwasher on using the sen-
sor
(1).
2. Touch the P sensor (2) for slightly longer
than 5 seconds until the indicator
flashes, and the display (5) shows the
degree of water hardness that was last
used.
3. Touch the P sensor until the desired set-
ting is displayed.
4. To save the setting, touch the sensor
or wait approx. 5 seconds until the dish-
washer automatically returns to the nor-
mal display.
The hardness level setting is saved.
Correct setting
(18)
(1),

Automatic regeneration

In order to make sure that the water soften-
ing system works, the water softening sys-
tem is automatically regenerated at regular
intervals.
The regeneration process of your appliance
begins with the drying cycle. The water and
energy consumption then increases and
the duration of the programme is extended.
There is no regeneration process in the short
programme.
The frequency of the regeneration process
depends on the selected water hardness:
°dH
Setting
0-5
H1
6-11
H2
12-17
H3
18-22
H4
23-34
H5
35-55
H6
Example ECO programme: with a water
hardness level of H3 and under laboratory
conditions, the duration of the programme in-
creases by 4 minutes. The energy consump-
tion increases by 0.02 kWh and the water
consumption by 2.0 litres.

Test run

It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the appli-
ance functions perfectly.
If no water escapes during the test run and if
there are no unusual noises, the appliance is
ready to use.
Carry out this test run when the dishwasher is
empty and without any dishwasher detergent.
See chapter"Operation" from page EN-22 for
the procedure.
Regeneration
process every
X programme
cycles
-
10
5
3
2
1

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Hgu6082c147735ti8680643327880738

Table of Contents