Checking And Cleaning The Spraying Arm And Spray Nozzles; Complete Cleaning; Protection Against Frost Damage - Hanseatic HGTI6082C147735TS User Manual

Page EN-28 Care and maintenance
Checking and cleaning the
spraying arm and spray
nozzles
The spray nozzles and the nozzles in the
spraying arm may calcify or become dirty due
to food scraps. Check the nozzles regularly
after each cycle and clean them if required.
1. Empty both dish racks (30)/(31) and re-
move the lower dish rack (31).
(33)
(34)
2. Turn the lower spraying arm (33) upward
and outwards.
3. The upper spraying arm (32) is affixed
using a bayonet closure. To remove the
spraying arm, hold the two serrated bay-
onet grips (47) still and turn the spraying
arm clockwise.
4. Clean the nozzles of the spraying arm un-
der running water.
5. Affix the spraying arm again after clean-
ing.
The spraying arm must be firmly affixed
and must be able to rotate freely.

Complete cleaning

In well-stocked supermarkets and drugstores,
you will find special dishwasher cleaning
products. Cleaning the appliance using these
products takes place when the dishwasher is
empty and is very intensive. You should clean
the dishwasher in this way from time to time.
When doing so, please note the manufactur-
er instructions on the packaging.
To prevent limescale deposits, please follow
the instructions for the correct setting of the
appliance (rinse aid and salt) (see "Dish-
washer detergents, rinse aids and dishwash-
er salts" on page EN-13).
Protection against frost
damage
Position the dishwasher in a room which is
protected from frost, if possible. If this is not
possible, protect the dishwasher against frost
as follows. You will need a shallow dish or a
(47)
pan, and a sponge.
1. Disconnect the mains plug from the sock-
et or switch off the fuse.
2. Close the tap and unscrew the inlet
hose (41).
3. Let the water from the inlet hose flow
completely into the dish.
4. Remove the (36) filters.
5. Remove the water from the sump floor
with the help of a sponge.