Epson WF-C5890 Series User Manual page 123

Preparing the Printer and Making Initial Settings
4. Select the Access Code box, and then select Use.
5. Tap the Access Code input box, enter the external access code used for your phone system, and then tap OK.
6. Select OK to apply the settings.
The #, entered instead of the actual access code, is replaced with the stored access code, such as 0 or 9, when
dialing. Using # helps avoid connection problems when connecting to an outside line.
Note:
When Access Code is set to Use, you cannot send faxes to recipients in Contacts for which an external access code such
as 0 or 9 is set.
If you have registered recipients in Contacts using an external access code such as 0 or 9, set the Access Code to Do Not
Use. Otherwise, you must change the code to # in Contacts.
Making Settings When You Connect a Phone Device
Making Settings to Use an Answering Machine
You need settings to use an answering machine.
1. Select Settings on the printer's control panel.
2. Select General Settings > Fax Settings > Basic Settings.
3. Set Receive Mode to Auto.
4. Set the Rings to Answer setting of the printer to a higher number than the number of rings for the answering
machine.
If Rings to Answer is set lower than the number of rings for the answering machine, the answering machine
cannot receive voice calls to record voice messages. See the manuals that came with the answering machine for
its settings.
The printer's Rings to Answer setting may not be displayed, depending on the region.
Related Information
"Basic Settings" on page 377
&
Making Settings to Receive Faxes Operating Only a Connected Phone
You can start receiving incoming faxes by only picking up the handset and operating the phone, without operating
the printer at all.
The Remote Receive feature is available for telephones that support tone dialing.
1. Select Settings on the printer's control panel.
2. Select General Settings > Fax Settings > Basic Settings > Remote Receive.
3. Tap Remote Receive to set this to On.
4. Select Start Code, enter a two digit code (you can enter 0 to 9, *, and #), and then tap OK.
>
Settings for Printing, Scanning, Copying and Fa
123
...