Result Codes - Multitech MT5634MU User Manual

MultiMobile USB User Guide
Register
S42
S43
S48
S89
S109

Result Codes

In command mode your modem can send responses called result codes to your computer. Result
codes are used by communications programs and can also appear on your monitor.
Terse
0
1
2
3
4
5 *
6
7
8
10*
11*
12*
13*
14*
24*
25*
26*
40*
44
Unit Range
decimal 0–1
decimal 0–1
decimal 7 or 128 7
seconds 0, 5–255 10
decimal 0--2
Verbose
OK
CONNECT
RING
NO CARRIER
ERROR
CONNECT 1200
NO DIALTONE
BUSY
NO ANSWER
CONNECT 2400
CONNECT 4800
CONNECT 9600
CONNECT 14400
CONNECT 19200
CONNECT 7200
CONNECT 12000
CONNECT 16800
CONNECT 300
Default Description
1 Enables/disables the 56K auto rate. When
56K auto is disabled, fallback to V.34 is also
disabled. 0 = disable; 1 = enable.
1 For testing and debugging only. Enables/
disables V.32bis start-up auto mode operation.
0 = disable; 1 = enable.
Enables (7) or disables (128) LAPM
negotiation. The following table lists the S36
and S48 configuration settings for certain
types of connections.
LAPM or hangup
S36=0, 2
LAPM or async
S36=1, 3
LAPM, MNP, or hangup
S36=4, 6
LAPM, MNP, or aysnc
S36=5, 7
Sets the length of time in the off-line command
mode before the modem goes into standby
mode. A value of zero prevents standby mode;
a value of 1–4 sets the value to 5.
1 Sets one of three 56K operating modes:
K56flex mode, V.90 mode, or Auto-mode.
S109=2 forces V.90 connections for testing
purposes, etc. S109 sets the 56K operating
mode as shown below:
0 = V.90 disabled
1 = K56flex or V.90 (Dual mode enabled)
2 = V.90 only (K56flex disabled).
Description
Command executed
Modem connected to line
Ring signal detected
Carrier signal lost or not detected
Invalid command
Connected at 1200 bps
No dial tone detected
Busy signal detected
No answer at remote end
Connected at 2400 bps
Connected at 4800 bps
Connected at 9600 bps
Connected at 14400 bps
Connected at 19200 bps
Connected at 7200 bps
Connected at 12000 bps
Connected at 16800 bps
Connected at 300 bps
S48=7 S48=128
Do not use
Async
MNP or hangup
MNP or async