34946A and 34947A Dual/Triple Microwave Switch Modules
34946A and 34947A Option 001 Installation
Option 001 to the 34946A and 34947A is a 30-pin ribbon connector to 9-pin
D-Sub connector cable kit. The option allows you to connect two (34946A) or
three (34947A) switches internal/ external to the instrument chassis. See the
following sections for instructions on connecting the switches internally and
externally.
Fastening of 9-pin D-sub connector to the ribbon cable
Before installing the switches to the 34946A/ 34947A modules, fasten the 25
strand ribbon to 9-pin D-Sub connector. If you are mounting the switches
externally, route the center and left 9-pin strands through the corresponding
slots of the instrument face plate. For more instructions, see
Externally to the Module
To fasten the 9-pin D-sub connector to the ribbon strand:
1 Cut a length of 25 strand ribbon cable long enough for the cable you wish to
2 Take out the connector(34946-80001) from its packaging as shown in the
3 Detach the 2 halves of the connector as shown below:
Keysight 34946A-34947A Microwave Switch/Driver Modules User's Guide
34946A Option 001 and 34947A Option 001as purchased meet all safety
and EMC regulatory requirements. Any modifications or additions to the
options and their conformance to local regulatory requirements are the
responsibility of the user.
make.
figure below:
section on page 13.
Installing Switches
11