Advertisement
Installation Procedure
Pull out the Anti-Tip Stabilizer before installing heavy equipment.
Preparing the Front Door Assembly
The front door assembly may be shipped already assembled. If so, skip this
section and go to the next section, "Attaching the Front Door To the Rack."
1. Slip the nylon washers over the threaded studs on the door frame
Do not overtighten the nuts. Use just enough tension to snug the nuts, but
be careful not to break the Plexiglas.
2. Attach the two hinge plates (with the spring-loaded pins) to the front
3. Attach the remaining part of the hinge assembly to the hinge brackets. Do
4. Attach the latch to the front door assembly. Insert the bolt through the
Keysight E4461B E4462B E4463B Front Door Kit Assembly
assembly (nylon washers are not used with the perforated door). Then
place the Plexiglas/perforated panel against the frame so the threaded
studs slide through the holes in the panel. Secure the panel with the
washers and nuts as shown in the diagram in Figure 1.
door assembly with the M3 nuts, as shown in Figure 2.
not over tighten the nuts.
latch bracket and into the latch itself, as shown in Figure 1.
7
Advertisement
