Multitech FaxFinder FF200 Quick Start Manual page 30

Server Installation
k2.Test Call - for POTS Mode (where the Routing field is set
to "Pots Line"). From a different POTS phone, dial the
number of the phone line to which the FF-200 FaxFinder is
attached.
l. In the Current Status: POTS Modem 1 screen, the "State"
field should change to "Waiting for Connect." On the
phone, you should hear modem dialup/negotiation tones.
m. If you both observe the "Waiting for Connect" state and hear
the tones, then the FaxFinder's Modem has been
configured properly.
If either of these is absent, see item #3 "What if the
FaxFinder doesn't answer a fax call?" in the
"Troubleshooting" chapter of the Administrator User Guide.
n. Repeat steps 8b through 8m for the FaxFinder's second
modem.
Multi-Tech FaxFinder Quick Start
30