Multitech RouteFinder RF820 User Manual page 64

Chapter 5 – Configuration Using Web Management Software
VPN > IPSec > Add Manual Connection
Left Next Hop
Next Hop is the address of the next device in a routing table's path that moves a packet to it's
destination. This setting can be configured or left as a static value: 0.0.0.0. When not configured, the
value is set to the Gateway of the Box/Gateway configured on the Interface/Right IP. The selection is
based on the Left and Right IP.
Local WAN IP
Select the Interface to initiate the IPSec tunnel (Left Security Gateway). Options are LAN, WAN1, and
WAN 2 (for the RF830/RF830-AP only).
Local LAN
Select the internal subnet of the local security gateway for which the security services are to be
provided. If the RouteFinder acts as a host, this should be configured as None. Other options are:
Any, LAN, LAN Interface, WAN 1, WAN 1 Interface. (RF830/RF830-AP includes WAN 2 and WAN 2
Interface options).
Remote Gateway IP
Select the interface in which the IPSec tunnel ends. In the case of Road Warriors with a Dynamic IP
addresses, this should be configured as ANY. Other options include: LAN, LAN Interface, WAN 1,
WAN 1 Interface, and None. (RF830/RF830-AP includes WAN 2 and WAN 2 Interface options).
FQDN
FQDN is a DNS resolvable fully qualified domain name with which identity the right peer can be
identified. When FQDN is entered, the Remote Gateway IP should be blank.
Remote LAN
This is the internal subnet of the remote security gateway for which the security services are to be
provided. If the remote end is a host, this should be configured as None.
Failover (available on the RF830/RF830-AP only)
Check the box to enable VPN failover for the tunnel. When this field is enabled, the tunnel will failover
on to the other interface if its local interface is down. For example, if the tunnel is configured on WAN
1 but the link goes down, the tunnel again comes up on the link that is up (i.e., LAN 2). Failover is
possible only when the remote gateway is an FQDN (Fully Qualified Domain Name) and Dynamic
DNS Failover is enabled (see the Network > Dynamic DNS screen).
NetBIOS Broadcast
Check this option to enable broadcasts over the connection. It will allow computers on the network to
share Microsoft file and printer sharing information.
Multi-Tech Systems, Inc. RouteFinder SOHO RF820/RF820-AP & RF830/RF830-AP User Guide (S000399E) 64