Table of Contents
Advertisement
THE SYSTEM CONTROL CONSOLE AND ITS INDICATORS
(1) THE MASTER CONTROL CONSOLE
(2) OPTIONAL CONTROL CONSOLE
One optional control console can be connected to the system at remote location
The Connection Terminals:
(+) 12V
:
+12V power input terminal, connect it to wire 5.
( ) 12V
-
:
Common grounding point, connect it to wire 9.
CLOCK
:
The clock of the system, connect it to wire 6.
DATA
:
The data signal of the system, connect it to wire 7.
TAMPER N.C. :
These are the connection terminals of the tamper switch on the control console.
Connection of it is optional. If required, connect it to a normally closed (N.C.)
24-hour zone.
D
NOTE:
Optional control console is required to purchase separately.
D
The optional control console can be used for HA-268 and HA-266, zone indicator 7
is not used and 8 is the tamper zone (T) in HA-266.
6
REMOTE CONTROL OF THE SYSTEM BY TELEPHONE
The HA-266 has been designed to allow the owner to telephone the system remotely
Program Location 83 for details)
to request the communicator for a current status report sending to the monitor station or to the
owner's pocket pager. The call can be made from any telephone capable of tone dialing,
including DTMF capable mobile telephones.
Please put a "
" in the box showing your selected option:
REMOTE ACCESS ENABLED
REMOTE ACCESS DISABLED
CHECKING THE ARM-DISARM CURRENT STATUS
1. Ring the number that the system is connected to. In most cases that is the home telephone
number of the owner.
2. After the pre-set number of rings
answer the phone with one of the following answering beeps to show its current status.
THE MEANING OF THE ANSWERING BEEPS--SUMMARY
NO.
ANSWERING BEEPS
1
1 beep
2
2 beeps
3
1 beep + 3 beeps
4
2 beeps + 3 beeps
5
1 beep + 2 beeps
6
5 beeps
7
2 beeps + 5 beeps
3. If you only wish to check on the CURRENT STATUS of the alarm system, without making
any change, simply hang up the phone after the answering beep is heard.
REMOTE ARM-DISARM THE SYSTEM
4. If you wish to change the status on the system, please enter the appropriate command code
using the telephone keypad after the answering beep is heard.
NOTE:
For obvious security reasons
ARM-DISARM control.
HA-266
HA-266
to check its arm-disarm status, to make arm-disarm control or
RINGS TO
PICK-UP
(
DEFAULT: 16
LINE
OPTION
SELECTED
(programmed at Location 83. DEFAULT: 16)
MEANINGS
!
System is disarmed
!
System is armed
!
System is disarmed, but
!
Alarm is occurred
(due to the 24 hours or the software zones)
!
System is armed, and
!
Alarm is occurred
!
System is disarmed, but
!
System is in alarm memory, at least one of the protection
zones was in alarm
!
Unsuccessful code entry, try again
!
Successful code entry but the function request is rejected
due to system arm prohibited
ONLY USER CODE 1
can be used for system remote
(See
)
the system will
71
Advertisement
Table of Contents
